2022 Developer Survey is open! Take survey.
Network Engineering

Scholar

 Scholar
Ask a question and accept an answer.
Awarded 5410 times.
How does wireshark calculate the TCP length when there is no header indiciating such?
Awarded 9 hours ago
Constraint on length of message & segment to be integral number of bytes, as mentioned in Cerf & Kahn's Paper
Awarded May 21 at 14:41
Why is the highest IP address taken as Router ID by default in OSPF?
Awarded May 20 at 13:33
Simple IPv6 Global Unicast question
Awarded May 20 at 13:07
What are the IP/MAC addresses of requests between 2 different subnets? [closed]
Awarded May 18 at 20:18
What does it mean to “plumb” an IP address?
Awarded May 17 at 0:34
Why shortened version of IP4 exists and it is undocumented but supported everywhere?
Awarded May 16 at 21:15
Will this switch do what I require?
Awarded May 16 at 9:06
Why the host part of a Mask is 254 (256-2) instead of 253?
Awarded May 11 at 19:56
TCP segment with flags ACK, PSH, URG
Awarded May 11 at 7:31
Difference between default routes
Awarded May 11 at 6:52
Regex for cisco acl
Awarded May 10 at 21:04
How to create a subnet or secondary network? Do I need VLANs?
Awarded May 10 at 16:16
Why should I use vlans instead of subnets?
Awarded May 7 at 10:05
How Does A Layer 2 Switch Differentiate Between Different Networks?
Awarded May 6 at 21:36
What's the point of aggregate routes when the default preference is reject?
Awarded May 5 at 2:41
How to change the source port without interrupt the TCP connection? [closed]
Awarded May 2 at 0:56
Ethernet: How does receiver know end of frame? [duplicate]
Awarded Apr 30 at 23:09
Which access methods and topologies are used for 10/40/100 Giga Ethernet?
Awarded Apr 29 at 21:27
show ip ospf neighbor unexpected results On packet Tracer
Awarded Apr 27 at 17:55
Switch with 100Mbit and 1Gbit ports - using its full capacity
Awarded Apr 27 at 16:46
Cisco BGP Configuration
Awarded Apr 26 at 14:27
MAC address table and frame forwarding on Layer 2 switches - question about when two computers are connected via hub to same switch port
Awarded Apr 26 at 4:17
Are WAN and "backbone" same?
Awarded Apr 24 at 16:20
How to redirect traffic when one site goes down without downtime and the subnets are different?
Awarded Apr 16 at 19:56
VLAN routing on the same subnet
Awarded Apr 13 at 17:10
Cisco ASR 1001 transceivers not working
Awarded Apr 8 at 8:27
How does a computer determine that an Ethernet frame contains an IP packet? [duplicate]
Awarded Apr 5 at 19:33
mount a industrial network [closed]
Awarded Apr 5 at 14:19
RIP always add same network adress
Awarded Apr 4 at 16:16
Why is Packet Size Limited?
Awarded Apr 1 at 20:11
How can a ping response fail from my modem, but succeed from my ISP and Google DNS (beyond the modem) within the same timeframe? [closed]
Awarded Mar 31 at 14:16
Inherent flaw in stateless firewalls?
Awarded Mar 31 at 11:51
Is site-to-site with Ubiquiti UDM Pro + USG + ERPro-8 behind ISP routers possible?
Awarded Mar 31 at 6:50
Network setup for multiple devices with the same IP
Awarded Mar 30 at 11:27
Netgear ProSafe switches - disable secondary (DHCP) management IP
Awarded Mar 30 at 7:40
Why is microwave faster than infrared as a transmission medium?
Awarded Mar 29 at 18:16
How does BGP router know the L2 address (MAC address) of the clients?
Awarded Mar 29 at 17:18
How Can a VPC ping the Router through an Etherswitch that behaves in one port as router and in the other as switch
Awarded Mar 28 at 23:33
Explanation about SNMPv3 USM
Awarded Mar 28 at 11:32
Custom option in IP header
Awarded Mar 25 at 21:11
How does providing IPv4 occur through mobile internet?
Awarded Mar 24 at 10:48
WAP configuration consistency
Awarded Mar 19 at 23:17
What is the behavior of two managed switches connected to one unmanaged switch?
Awarded Mar 18 at 2:49
OSPF Theory Question | Topology Changes | LSU Flooding
Awarded Mar 16 at 14:20
Display interface - wrong parameter
Awarded Mar 16 at 3:48
Is there any other scenario of TCP segment window size equal 0?
Awarded Mar 16 at 2:10
How to add the Hyper-V Virtual Machine to GNS 3?
Awarded Mar 14 at 9:40
Packet capture shows packets larger than MTU
Awarded Mar 11 at 16:11
When in Cisco ASA multiple context mode, does each context have a startup and running config?
Awarded Mar 11 at 3:15
Does pulses in telephone copper wire count as frequncy?
Awarded Mar 10 at 18:11
Do IDS/IPS/HIDS slow your network down?
Awarded Mar 3 at 20:16
Trunk seems to be allowing all vlans
Awarded Mar 3 at 16:57
What does the number after the arguments mean in these commands?
Awarded Mar 3 at 6:21
Why does redistributing ospf in rip change the path of all routers on the rip network that are not directly connected to the router that redistributed
Awarded Mar 2 at 23:21
what are the difficulties of configuring switches through SNMP?
Awarded Mar 1 at 20:42
Why is a switch port a collision domain?
Awarded Mar 1 at 14:04
Same subnet on multiple VPN clients
Awarded Mar 1 at 13:05
(post deleted or otherwise unavailable)
Awarded Feb 26 at 8:41
What is the difference between server-side and client-side data transfer rates in a speed test?
Awarded Feb 25 at 11:04
1
2 3 4 5
…
91

Your privacy

By clicking “Accept all cookies”, you agree Stack Exchange can store cookies on your device and disclose information in accordance with our Cookie Policy.