3

Good morning all,

I was curious due to an issue were currently troubleshooting in our environment if there is a command in Juniper that will allow us to determine the utilization percentage of an interface on the MX480 along with the SRX550 platforms. I know "monitor interface ge-2/3/8" for example would give me live rates for the interface referenced in the command however I am looking for interface utilization percentages versus bits/sec or packets/sec.

I recall when I worked in predominantly Cisco environments You could obtain this data rather easily. I am just wondering if there is an equivalent in the Juniper world. Thanks in advance

Improve this question
2
  • Can you mention what do you mean by 'something more?
    – Nabeel
    Commented Mar 8, 2019 at 18:21
  • I have edited my above question to reflect what I am looking for.
    – Ty Smith
    Commented Mar 8, 2019 at 19:01

1 Answer 1

Reset to default
3

monitor interface and show interface <...> detail are the commands most often used. However, I don't think many people use a CLI nowadays to get this information. There are many tools which use either SNMP or (even better) streaming telemetry to retrieve this information from a network device and display it in any way you like.

Improve this answer

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.