I'm developing a
SNMP Monitor for my company. I've done it before, and that is why I'm not sure why I have the behavior, and because I'm not a network engineer, I'm not a 100% sure where to go and trouble shoot the problem.
OID 188.8.131.52.184.108.40.206.1.10 (In Octets for an interface) and I receive a value. However, If I request it again 5 seconds later, I get exactly the same value, but 5 seconds later there is movement. If I request it every 10 seconds, there is movement all the time. (I do request the Out Octets as well, and experience the same behavior)
If I log on to the router and I run
sh int fastEthernet 0/0/0 the input bytes changes the whole time like I expect.
At my previous company I did a similar monitor, and I requested the value every 2 seconds, and it worked fine. Unfortunately I cannot remember the series of the Cisco routers there.
Running Wireshark I see the requests and responses, and the response from the router definitely returns the same value.
I have 3 questions regarding this.
- Is there a setting or configuration that I can set?
- Will it be better to use traps instead of query?
- Is this native to the 1900 series to only update the SNMP agent (forgive me if this is the wrong terminology) like it is doing at the moment.
Any help in any direction will be appreciated. If there is any information that you need that I might have left out, please ask. Like I said, I'm not a network engineer.
Thanks in advance