I recently replaced wireless at a site from the internal AP on an 877-WM with a (standalone) 1262 running 15.2(2)JB. I've configured the AP pretty much the same as I always do for Cisco AP's for single SSID operation (single bridge domain, BVI1 also management), and things seem to work.
However on my laptop I have VMware running, and a guest with NIC set to bridged mode is unable to DHCP, however IPv6 works fine.
When searching for this problem I see a reference to a "ip-mac-binding disable" command on WLC setups, but can't find if that maps to a setting on a single AP.
The relevant part of the AP's configuration is:
dot11 ssid # Removed authentication open authentication key-management wpa guest-mode mbssid guest-mode wpa-psk ascii # Removed ! bridge irb ! interface Dot11Radio0 no ip address ! encryption mode ciphers aes-ccm ! ssid # Removed ! station-role root bridge-group 1 bridge-group 1 subscriber-loop-control bridge-group 1 spanning-disabled bridge-group 1 block-unknown-source no bridge-group 1 source-learning no bridge-group 1 unicast-flooding ! interface Dot11Radio1 # Pretty much the same as radio 0 interface GigabitEthernet0 no ip address duplex auto speed auto no keepalive bridge-group 1 bridge-group 1 spanning-disabled no bridge-group 1 source-learning