5

I read about CDP - which says its a cisco protocol. It lists devices that are connected to each other. But if i don't have all cisco vender, how can I see what connects where?

I have cisco router R1 connected to another vender router R2, and from there to another cisco R3. CDP can only show R1 connecting to R3? How can I see R2?

3

Actually even with CDP you cannot see R3 as being neighbors with R1. CDP, is link-local. Which basically means that CDP can only show devices directly connected as neighbors 1 hop away. In your example, R3 is two hops away. Unless it has another directly connected link to R1, it won't become a CDP neighbor.

What you are looking for is LLDP. Its can run on CISCO as well as most other vendor gear. And it functions similar to CDP - shows the immediate neighbor.

| improve this answer | |
  • What is link-local mean? – ccnaQuest Sep 30 '15 at 1:27
  • 2
    See Ron's answer for an explanation of link-local. Its only valid on the connected link, and not beyond it. Hence with these protocols, you get a picture of only whats on the other end of the link, not whats another router away – ajaysdesk Sep 30 '15 at 1:29
1

As @ajaysdesk writes, CDP and LLDP are only valid on the link on which they are originated. These protocols use special layer-2 frames which are not switched or routed beyond the device on the other end of the link.

| improve this answer | |

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.