1

I have been playing with network stuff so I installed GNS3 network simulator.

I have deployed ASA 8.4 image and it has loaded fine.

I connected it with basic Switch

switch-----ASA

I have configured IP address on an interface and executed no shut. I then tried to ping itself but ping did not work :(

I have restart GNS3 also but didn't work :(

interface GigabitEthernet0
 no nameif
 no security-level
 ip address 192.168.56.2 255.255.255.0
!

Trying to ping itself

fw01# ping 192.168.56.2
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.56.2, timeout is 2 seconds:
No route to host 192.168.56.2

Success rate is 0 percent (0/1)
fw01#
  • Did any answer help you? if so, you should accept the answer so that the question doesn't keep popping up forever, looking for an answer. Alternatively, you could provide and accept your own answer. – Ron Maupin Aug 12 '17 at 20:00
2

You need to set the interface name otherwise the interface will remain unreachable.

e.g.

interface gi0
 nameif inside
 ip address 10.0.0.1 255.255.255.0
 no shutdown

To verify your interface status

show int ip brief
  • You also need a security level configured. Although most code versions will automatically set a security level of 0 for you once you set the name. Except if you set the name inside, in which case it sets a security level of 100. – Eddie Dec 29 '15 at 20:38
2

I believe you also have a set a security level for the interfaces in an ASA. From what I remember, there's three things that need to be configured for each interface:
Name Security Level IP Address

  • Hi MMusgrove, welcome to NESE. You posted the correct answer, however, would you be willing to elaborate and/or provide syntax or configuration examples to help the original poster and future readers? – Eddie Dec 29 '15 at 20:39

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.