3

I configured a Cisco H323 Gateway between 2 CUCMs connected via Intercluster trunk(non-gatekeeper controlled) Dial peer configuration is :

dial-peer voice 10001 voip  
destination-pattern 3971...   
session target ipv4:10.10.10.1    
session transport tcp    
incoming called-number .    
dtmf-relay h245-alphanumeric    
codec g711ulaw    
!   
dial-peer voice 10002 voip   
destination-pattern 2971...    
session target ipv4:10.10.10.2    
session transport tcp    
incoming called-number .    
dtmf-relay h245-alphanumeric    
codec g711ulaw   

Call entered the gateway and not routed to the destination.

2
  • the call can inter the VG from the two sides but can't out – Gadeliow Oct 21 '15 at 13:28
  • Did any answer help you? if so, you should accept the answer so that the question doesn't keep popping up forever, looking for an answer. Alternatively, you could provide and accept your own answer. – Ron Maupin Aug 12 '17 at 20:10
1

if the call can inter the VG from the two sides but can't out you may need to add the next lines to your configurations :

Router(config)# voice service voip 
Router(config-voi-serv)# allow-connections h323 to h323
Router(config-voi-serv)# allow-connections sip to sip
Router(config-voi-serv)# allow-connections h323 to sip
Router(config-voi-serv)# allow-connections 

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.