Please explain the flow of traffic in each case.

  • Did any answer help you? If so, you should accept the answer so that the question doesn't keep popping up forever, looking for an answer. Alternatively, you can provide your own answer and accept it.
    – Ron Maupin
    Aug 7, 2017 at 15:24

3 Answers 3


They are aimed at different network layers. Every layer-2 broadcast must be inspected and processed by every host to see if it should be passed up to layer-3. A layer-3 broadcast received by a host must be inspected and processed to see if it must be passed up to layer-4.

I suppose it would be possible to create a layer-2 frame which is a layer-2 unicast frame but contains a layer-3 broadcast address. This would not really be a broadcast since it only goes to a single host based on the layer-2 MAC address.

ARP is an example of a layer-2 broadcast which has a layer-3 unicast address. Each host must inspect the layer-2 ARP broadcast to see if it should be passed up to layer-3, but only the host with the layer-3 unicast address will actually pass the layer-2 broadcast up the stack.


The layer 2 broadcast address ff:ff:ff:ff:ff:ff is used on ethernet frames and is supposedly broadcasted on all equipments. is the layer 3 address that is used to adress the exact same hosts.

Note that:

  • IP can support all kind of networks, so ethernet won't be always used.
  • Reciprocally ethernet can be used without IP (appletalk, IPX, ...).
  • One layer 2 media can share several IP networks, but it is really bad practice: broadcast limits should be the same at layer 2 and 3 (for instance if and are located on the same switch and same vlan: bad idea).

The flow of traffic in each case goes like this.

Let's take Ron's example of an ARP Request. So the layer 2 destination address is ff:ff:ff:ff:ff:ff which is a broadcast. The layer 3 address however may be which is probably the IP address of the host that you're trying to find the MAC address for. Now this ARP packet is sent out on the network and every host on the network receives it. Each host is going to first receive it, run a CRC on it and if pass, will go on to check the layer 2 address. Now since it's a broadcast, it's going to pass through and then it will check the layer 3 address. Those that do not match, discard the packet. The one that does match then forms a response packet with it's MAC address, sets the layer 3 destination as our original source (say and layer 2 destination as the MAC address of our source.

Like Ron mentioned, the difference is mainly where it's processed. While MAC addresses are processed in layer 2, IP addresses are looked at only at layer 3. Sometimes, the device might not even look at the IP address and directly discard the packet after checking layer 2 information.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.