How do i telnet back?

I have done stacking using 2 dummy HP Pro Curve 2610. Gateway for Commander is , while member has

I was in Commander Switch, then i telnet to the Member Switch.

The issue was that, when i am in Member Switch, i could not telnet back to Commander Switch.

I realize that when i use "Sh Stack All" , my Commander Switch does not have Commander IP.

How do i rectify all these and telnet back to Commander?

Commander is 1-0 Member is 1-1

  • Did any answer help you? if so, you should accept the answer so that the question doesn't keep popping up forever, looking for an answer. Alternatively, you could provide and accept your own answer.
    – Ron Maupin
    Commented Aug 11, 2017 at 14:31

1 Answer 1


Normally, if you nest telnet sessions, you just need to exit the last one to get back to the previous one. In your case, the chain would be Putty->Commander->Member. By exiting the Member session, you'll get back to the commander.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.