9

In EIGRP when showing topology table, i notice in some entries are like below:

P 10.1.6.0/24, 1 successors, FD is 793600
            via 10.1.2.2 (2195456/281600), Serial0/0/0
           via 10.1.3.2 (77081600/281600), Serial0/0/1

It seems the successor should be 10.1.2.2, but why its FD shows 2195456, not equal to 793600?

1
  • Did any answer help you? If so, you should accept the answer so that the question doesn't keep popping up forever, looking for an answer. Alternatively, you can post and accept your own answer.
    – Ron Maupin
    Jan 3, 2021 at 6:02

1 Answer 1

3

When you manipulate the various k-values in order to affect route preference, this sort of output will sometimes be displayed until you reset your EIGRP neighbors. You can accomplish this by entering the following command(assuming Cisco gear): clear ip eigrp (AS#) neighbors where (AS#) is the EIGRP autonomous system number. The few times I have seen output similar to that posted(all in lab scenarios, btw), this has fixed it.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge that you have read and understand our privacy policy and code of conduct.