2

I am using GNS3, and a 3700 as L3 switch (router with ethernet switch module); everything is OK, but when I want to configure two ports as an etherchannel connection, the command channel-group doesn't have mode on.

Can anyone help me?

1
  • 1
    What version of IOS are you using?
    – Ron Trunk
    Apr 22, 2016 at 19:01

1 Answer 1

2

The problem was existing because I was not using ether switch module ports that is added to router to handle it as switch

1
  • Good find. You should mark your own answer as the accepted answer if the question was resolved.
    – Eddie
    May 23, 2016 at 15:17

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge that you have read and understand our privacy policy and code of conduct.

Not the answer you're looking for? Browse other questions tagged or ask your own question.