3

Is this command disruptive or just a logical exercise of existing configuration?

test etherchannel load-balance int po3 <some mac here>

Platform is 6500 series, running IOS. Thank you!

2

Not so far as I am aware. All it does is simulate sending data and seeing which interface would actually be carrying the packets.

Granted this is to the best of my knowledge and I might be incorrect.

| improve this answer | |
  • Thanks for the feedback Zack, I need to make sure it's non-impactful before I can execute though so I'll leave this open for now. – A L Sep 8 '16 at 14:26
  • 2
    @AL, the command only runs the hash algorithm to see which member interface would be used for traffic. – Ron Maupin Sep 8 '16 at 14:26
  • @RonMaupin - thank you sir, and thank you again Zack for reaching out, flagging as correctly answered! – A L Sep 8 '16 at 14:32

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.