1

I tried upgrading ASA 5506W AP and upload the wrong image k9w8- full lightweight instead k9w7- autonomus. How to fix it

3
  • Are you going to rommon mode? Just reupload right image. Dec 21 '16 at 10:37
  • How to do it? You can specify the procedure step by step.
    – mszreiter
    Dec 21 '16 at 18:26
  • Did any answer help you? If so, you should accept the answer so that the question doesn't keep popping up forever, looking for an answer. Alternatively, you could provide and accept your own answer.
    – Ron Maupin
    Aug 15 '17 at 17:01
1

From the Cisco Documentation:

Recover and Load an Image for the ASA 5506W-X Wireless Access Point

To recover and load a software image onto an ASA 5506W-X using TFTP, perform the following steps.

Procedure

  • Step 1 Session to the access point (AP) and enter the AP ROMMON (not the ASA ROMMON):

ciscoasa# hw-module module wlan recover image

1
  • How to connect to the ASA 5506W-X Series Access Point Locally?
    – mszreiter
    Jan 13 '17 at 12:04

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.