1

I would like to enable the jumbo frame support on my N5k for specific SCSI trafic.

I've read we can't do it per interface but only on the system itself :

policy-map type network-qos JUMBO_MTU
  class type network-qos class-default
    mtu 9216

!

system qos
  service-policy type network-qos JUMBO_MTU

But this enables jumbo frame on the whole switch. Can I identify the SCSI traffic on the policy-map so that it's applied just for the traffic I want?

And so the jumbo from other type of traffic would be processed normally ?

Thanks,

4

Yes you can, you just have to classify the traffic. Here is an example where we classify iSCSI into its own class. The class-default class will match any other traffic.

class-map type qos match-all iSCSI
  match protocol iscsi
  match cos 4

policy-map type qos POLICY-QOS
  class iSCSI
    set qos-group 3
  class class-fcoe
    set qos-group 1

class-map type network-qos iSCSI
  match qos-group 3

policy-map type network-qos JUMBO
  class type network-qos iSCSI
    mtu 9216
    pause no-drop
  class type network-qos class-fcoe
    pause no-drop
    mtu 2158
  class type network-qos class-default
    multicast-optimize


system qos
  service-policy type network-qos JUMBO
  service-policy type qos input POLICY-QOS

Just an additional note, you should modify the classification to match your environment and requirements. You can classify based on other criteria as well such as IP address.

class-map type qos match-all iSCSI
  match access-group name PERMIT-ANY

Edit:

N5K Configuration Guide

3
  • Thank you very much! I don't understand all the commands but I will work on it. If you tell me that I can change MTU for iSCSI and doing noting for other traffic it's perfect – Jey10 Jan 20 '17 at 13:30
  • Just an obvious question, as I read it, this system qos is applied on all FEX connected to the N5k ? Sorry but another question, does it hurt the cpu to add that on the system qos? – Jey10 Jan 20 '17 at 13:31
  • It applies to all interfaces including FEX. I believe the QoS is done in hardware and shouldn't impact the CPU. I haven't seen any CPU increase on our N5Ks. I added a link to the N5K config guide that might be helpful. – John K. Jan 20 '17 at 16:14

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.