I have successfully connected to Alcatel OmniPCX device via Serial COM port with help of XShell program to config interface.
It says that it is connected. It doesn's ask for login and password.
But I have to write login and password to continue my configuration.
How and where can I write my login and password?
Thank you guys!

  • 1
    Please paste the output of this command: show aaa authentication
    – Mr.lock
    Mar 13, 2017 at 12:30
  • @Mr.lock, the problem was in cable. It needed specific cable, which after that loaded its bios and asked for login and password. Mar 16, 2017 at 7:50
  • Did any answer help you? If so, you should accept the answer so that the question doesn't keep popping up forever, looking for an answer. Alternatively, you could provide and accept your own answer.
    – Ron Maupin
    Aug 17, 2017 at 4:22


Browse other questions tagged or ask your own question.