1

I have 2 Switches I made either channel between them , but every switch is connected with other links through other switches that can reach the destination and the spanning tree makes the channel not designated and all messages does not send through it .

is there any way to select the path I want? ?

Is there any way to change the cost ?

Improve this question
2
  • Can you post your topology?
    – TDurden
    May 7, 2017 at 5:14
  • Did any answer help you? If so, you should accept the answer so that the question doesn't keep popping up forever, looking for an answer. Alternatively, you can provide and accept your own answer.
    – Ron Maupin ♦
    Feb 19, 2018 at 3:52

1 Answer 1

Reset to default
2

You can modify the root bridge and priority to modify the blocking/forwarding ports of STP.

It is dependant on your setup so without seeing the topology it is a little hard to assist with how you want the setup.

You can find some information on configuring STP on cisco devices here:

http://www.cisco.com/c/en/us/support/docs/lan-switching/spanning-tree-protocol/5234-5.html

Improve this answer

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge that you have read and understand our privacy policy and code of conduct.

Not the answer you're looking for? Browse other questions tagged or ask your own question.