I'm trying to get our local Sonicwall NSA 2600 to connect to a AWS VPN, within a VPC. I have the IKE portion working and AWS shows the two pipes are connected

The BGP routes show as up in the router

(config-routing)# show routing bgp summary
BGP router identifier, local AS number 65000
BGP table version is 8737
2 BGP AS-PATH entries
0 BGP community entries

Neighbor        V    AS MsgRcvd MsgSent   TblVer  InQ OutQ Up/Down  State/PfxRcd  4  7224   51909   63298     8736    0    0 5d20h55m        1  4  7224   52390   63791     8736    0    0 5d20h55m        1

Total number of neighbors 2

What's baffling is that it appears that everything appears to be there. But attempting to get anything to route to the block doesn't work (I know it's a public block but I can't change it at present)

(config-routing)# show routing nsm database

C    *> is directly connected, T2
C    *> is directly connected, T2
C    *> is directly connected, T1
C    *> is directly connected, T1
B    *> [20/100] via, T1, 5d20h57m
C    *> is directly connected, X0

I've never dealt with BGP so I'm at a complete loss how to debug it further, or determine how to get it to send into or out of the VPC. I cannot get pings, RDC or SSH to work through the internal IPs.

Adding the route table, as obtained from my PC

IPv4 Route Table
Active Routes:
Network Destination        Netmask          Gateway       Interface  Metric
    281         On-link    331         On-link    331         On-link    331         On-link    281         On-link    281         On-link    281         On-link    331         On-link    281         On-link    331         On-link    281
Persistent Routes:
  Network Address          Netmask  Gateway Address  Metric

There is a route in the Sonicwall routing

I played with this some and got the BGP routes listed correctly, but still no luck on getting traffic to flow

   Network          Next Hop            Metric LocPrf Weight Path
*         200             0 7224 i
*>                 100             0 7224 i
*>                       100  32768 i
  • Are you using those link-local addresses based on the tutorial or from your actual configuration? I've never used AWS but that seems strange. Can you ping the BGP neighbors?
    – Zac67
    Jun 11 '17 at 21:10
  • what is your route for in the routing table?
    – john
    Jun 11 '17 at 22:41
  • I cannot ping the BGP neighbors. The addressing was provided directly by AWS itself
    – Machavity
    Jun 12 '17 at 12:38
  • 2
    It's hard to help you if you just keep spoon-feeding us information. Please post your router configs and the routing table from both sides. From what you've posted so far, I don't see a route from the VPC back to you.
    – Ron Trunk
    Jun 14 '17 at 17:17
  • 1
    Please post your router configuration
    – Ron Trunk
    Jun 14 '17 at 22:10