I try to create a Vlan that route traffic through multiple Cisco Devices. For that I create a vlan13 on each device and setup a IP on the ISR and the Device attached to the Nexus also have a IP on the same subnet.
The setup is like this:
interface Vlan13 description pfsense subnet ip address 10.1.1.49 255.255.255.240 end interface Ethernet-Internal1/0/0 description Trunk to internal switch module switchport trunk allowed vlan 1,11,13 switchport mode trunk end
interface Vlan13 ip address 10.1.1.51 255.255.255.240 end interface GigabitEthernet0/2 switchport trunk encapsulation dot1q switchport trunk allowed vlan 1,13 switchport mode trunk end interface GigabitEthernet0/52 switchport trunk encapsulation dot1q switchport mode trunk switchport protected end
vlan 1,13 interface Ethernet1/16 switchport access vlan 13 interface Ethernet1/47
I try to add
switchport trunk encapsulation dot1q to the nexus config but the command is unavailable. Maybe this is the issue of my config. The Server attached to the Eth1/16 Port is configured with IP 10.1.1.50/28 and the IP 10.1.1.49 or 10.1.1.51 is not accessible from that server.