1

So I have a cisco 2811 router and 2 3560 switches

Currently the router is connected to Core1 only, what i would like to do is use the other port on the router (fa0/1) to connect to Core 2.

How do I go about doing this? The router currently has the ip 192.168.1.1 and Core 1: 192.168.1.251 Core 2: 192.168.1.252

I tried to make another interface on the router but it complained that the ip address that I set conflicted with the one of fa0/0 to Core 1

2

You need to enable IRB (integrated routing and bridging) on the two router ports. You create, in essence, a L2 bridge between them. You then put the IP address in the BVI (bridge virtual interface).

Be sure to enable spanning tree, as you are creating a second L2 path.

2
  • Please could you give me an insight as to the commands I would need to enter? – NickCarlt Feb 2 '18 at 18:46
  • This document should be able to help you out with getting IRB configured. – A-A-Ron Feb 2 '18 at 18:46
3

As router is layer3 devices .Hence each interface connected and configured with each networks .

In this scenario both core1 & core 2 switch are connected with two router interface with same networks ip address 192.168.1.X . That's the reason getting ip address conflict error while other router port configured .

To avoid this error configure another networks address to another router interfàce .

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.