4

I'm using this command to show the MAC address table on a Juniper EX4500 series Virtual Chassis with 2 members:

show ethernet-switching table

The results show only interfaces for the Virtual Chassis master, although there are some ports connected on the VC slave. The ports have been added to the default VLAN and show up everywhere else as normal, in the config and with show interfaces.

How can I show the MAC table for ports on the secondary VC member?

Improve this question

1 Answer 1

Reset to default
3 
user@host> show chassis mac-addresses
MAC address information 
  Public base address   0:90:69:0:4:0
  Public count       1008
  Private base address   0:90:69:0:7:f0
  Private count       16
Improve this answer
1
  • Thanks, for some reason I couldn't find this anywhere. It works in regular cli mode, doesn't work in edit modes naturally.
    – László Kovács
    May 22, 2018 at 2:17

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge that you have read and understand our privacy policy and code of conduct.

Not the answer you're looking for? Browse other questions tagged or ask your own question.