2

I need help as Event manager applet not getting recognized for Cisco ASA ver8.0. But for cisco ASA ver 9.6 it is working properly. Please advise 

BnglASA/pri/act(config)#Event manager applet backupconfig
BnglASA/pri/act(config-applet) # description "Monthly backup of ASA" 
BnglASA/pri/act(config-applet) # event timer watchdog time 108000
BnglASA/pri/act (config-applet #action 1 cli command "copy /noconfirm running-config ftp://utiftp:[email protected]/"
BnglASA/pri/act(config-applet) #output none
Improve this question
1
  • 1
    Did any answer help you? If so, you should accept the answer so that the question doesn't keep popping up forever, looking for an answer. Alternatively, you can provide and accept your own answer.
    – Ron Maupin ♦
    Commented Dec 25, 2018 at 8:31

1 Answer 1

Reset to default
2

The feature was introduced in version 9.2.1:

Release Notes for the Cisco ASA Series, 9.2(x)

We introduced or modified the following commands: event manager applet, description, event syslog id, event none, event timer, event crashinfo, action cli command, output, show running-config event manager, event manager run, show event manager, show counters protocol eem, clear configure event manager, debug event manager, debug menu eem.

-and-

ASA Embedded Event Manager Configuration Example

This document describes Embedded Event Manager (EEM), which is a troubleshooting tool that was added in Adaptive Security Appliance (ASA) Version 9.2(1). The functionality is similar to Cisco IOS? based EEM. It is a powerful way to run CLI commands based on ASA events (syslogs) and save the output. This document covers an introduction to the feature as well as some example EEM applets.

Improve this answer

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.