I'm currently studying for my CompTIA Network+ Exam and am a bit confused as to why the IPv6 link-local address is a /10 and not a /12 or /16. Since each character in an IPv6 address is 4-bits and each section of a IPv6 address contains 4 hexadecimal characters, how can you effectively "split" a character and have a /10? And then on top of that, link-local addresses always starts with FE80, correct? And isn't 8 in binary 1000? It's not making any logical sense to me why /10 is used over /12 or /16. Any help and insight will be much appreciate! Thanks!

1 Answer 1


It is because IP addresses are binary numbers. The text representation is simply to make it easier for humans to read. RFC 4291, IP Version 6 Addressing Architecture explains the 10-bit prefix:

2.5.6. Link-Local IPv6 Unicast Addresses

Link-Local addresses are for use on a single link. Link-Local addresses have the following format:

|   10     |
|  bits    |         54 bits         |          64 bits           |
|1111111010|           0             |       interface ID         |

Link-Local addresses are designed to be used for addressing on a single link for purposes such as automatic address configuration, neighbor discovery, or when no routers are present.

Routers must not forward any packets with Link-Local source or destination addresses to other links.

You can break IPv6 prefixes on any bit boundary, just like you can with IPv4 prefixes, although the recommendation is to break IPv6 prefixes on nibble (hexadecimal character, four-bit) boundaries, it is not a requirement. Other IPv6 ranges break on non-nibble boundaries, too. For example the ULA addressing range is fc00::/7.

Before you ask why it isn't fe80::/64, see the answer to this question.

  • Ron, thank you for your reply. Just to make sure I am grasping things correctly, since the 54 bits following the initial 10 bits have to be 0s, this would ultimately render the third nibble 1000, which translated into hex would be 8? Thanks again. My brain was stuck in hex!
    – ahelton
    Jun 16, 2018 at 0:34
  • 2
    This doesn't answer the question, you're just quoting the RFC. The question is Why is it a /10 and not a /12 or /16. Why couldn't the link local scope have been FE8x::/12, or FE80::/16.
    – jester
    Aug 7, 2023 at 17:24

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.