2

In packet tracer if you hover over a router you will see its interfaces with IP addresses, vlans, etc. However during my CCNA exams (during the troubleshooting) this feature is disabled. Is there a command in the CLI that shows this information?

5

The most common commands are

show interfaces
show ip interface brief

Or for a specific interface

show interfaces vlan 1
| improve this answer | |
  • Yes thanks this is what I was looking for! – Sinan Samet Aug 28 '18 at 17:27
  • Glad to help. If you accept an answer, click on the check mark or the answer becomes an undead zombie, and will come around every few months hoping to be resolved. – jonathanjo Aug 28 '18 at 17:32
  • Yes thanks I'm just waiting till I am able to. – Sinan Samet Aug 28 '18 at 17:34

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.