2

In packet tracer if you hover over a router you will see its interfaces with IP addresses, vlans, etc. However during my CCNA exams (during the troubleshooting) this feature is disabled. Is there a command in the CLI that shows this information?

1 Answer 1

5

The most common commands are

show interfaces
show ip interface brief

Or for a specific interface

show interfaces vlan 1
3
  • Yes thanks this is what I was looking for! Commented Aug 28, 2018 at 17:27
  • Glad to help. If you accept an answer, click on the check mark or the answer becomes an undead zombie, and will come around every few months hoping to be resolved.
    – jonathanjo
    Commented Aug 28, 2018 at 17:32
  • Yes thanks I'm just waiting till I am able to. Commented Aug 28, 2018 at 17:34

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.