Well, my idea is to connect to 4
CSR 1000v routers in different VPC (without VPC peering).
I've basically finished with everything with the pre-configuration creating VPCs, subnets IGW, modifying Route Tables ... etc. Then, using
IPsec over GRE tunnels, the 4 instances can see each other. (Thanks to @MLu for suggesting this idea How to do routing between the instances in AWS using Route Table?
After having 4 instances and each of them their Primary Network Interfaces is associated with public IP addresses (
184.108.40.206 is for
220.127.116.11 is for
CSR2). I saw this video where I almost have the same configuration YouTube Video link. I started to configure the tunnel between 2
CSRs 1000v routers, where I created an interface inside the router called
Tunnel 0 with its source interface which is here
GigabitEthernet 1 so my configuration is the following:
CSR1(config)#interface tunnel 0 CSR1(config-if)#tunnel source GigabitEthernet 1 CSR1(config-if)#tunnel destination 18.104.22.168 CSR2(config)#interface tunnel 0 CSR2(config-if)#tunnel source GigabitEthernet 1 CSR2(config-if)#tunnel destination 22.214.171.124
Then I configured the IP addresses of these both tunnels' interfaces as it shows in the figure below.
CSR1(config)#int tun 0 CSR1(config-if)#ip address 10.10.1.2 255.255.255.252 CSR2(config)#int tun 0 CSR2(config-if)#ip address 10.10.1.1 255.255.255.252
My problem now is that the status of these tunnels' interfaces are
down as it shows
show ip int br:
Interface IP-Address OK? Method Status Protocol GigabitEthernet1 126.96.36.199 YES DHCP up up Tunnel0 10.10.1.1 YES manual up down VirtualPortGroup0 192.168.35.101 YES NVRAM up up
I realized that I have to create a subnet for the tunnel which I did at the end
10.10.1.0/28 then I created other interfaces in all instances.
My idea is to attach those new interfaces with a generated public IP address then I will get a new interface which is
GigabitEthernet 2 obviously, and I continue the configuration using this new interface
GigabitEthernet 2 instead of
Tunnel 0. Can I do the same configuration for tunnels in GigabitEthernet interfaces? I'm not sure if I am on the right track.