I am working on setting up routing on a HP 2920 to a firewall. I can not figure out what I need to do to get this set up. I know that the ip routing command turns on routing and the ip route command sets the route, but I don't know what address, subnet or gateway to use. Also, is there anything in particular I need to set my default gateway as on the switch itself?

  • Did any answer help you? If so, you should accept the answer so that the question doesn't keep popping up forever, looking for an answer. Alternatively, you can provide and accept your own answer. – Ron Maupin Dec 14 '19 at 18:34

With ip routing in the config, the 2920 routes between all of its VLAN interfaces. For each VLAN, you need to configure an IP address, e.g. on VLAN 99:

VLAN 99 ip address

Make sure you also either add remote routes statically (ip route for a default route via or run OSPF or RIP to learn the routes from the other routers.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.