6

I want to display the whole MAC address table without needing to press 'space' for the next page, so that if there are 50 entries in the table I'd be able to view them with a single command.

I'm working on an HP switch.

|improve this question
6

You can either adjust the screen length as Konstantin has suggested (screen-length disable isn't available on many switches though) or you can disable paging altogether using

no page

Re-enable with page.

|improve this answer
  • Do i use it on privileged exec mode? – user19215 Feb 20 at 17:51
  • @user19215 At least on Provision series switches [no] page works in all modes. – Zac67 Feb 20 at 18:13
  • Thank you Zac . – user19215 Feb 20 at 18:17
6

For HP you can use:

in user-view : screen-length disable

Then all output will be without "page" interruption.

|improve this answer
  • @jonathanjo On Cisco IOS devices, you mean. On Cisco ASAs, it's pager lines 0 – Jesse P. Feb 20 at 12:36
  • @JesseP. thanks for addition – jonathanjo Feb 20 at 16:39
  • Just for cross-reference, on Cisco IOS it's term length 0 – jonathanjo Feb 20 at 16:40
  • 1
    @jonathanjo Sure. I know this post was about switches but I wanted to make sure people knew about Cisco command differences between models (because can't standardize anything, apparently). – Jesse P. Feb 20 at 16:55

Your Answer

By clicking "Post Your Answer", you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.