6

I've tried to log in to this device by doing the following.

  1. Default credentials

    username: admin
    password: <none>
    
  2. Maintainer credentials in the FortiExplorer console interface.

    username: maintainer
    password: bcpb + serial number
    
  3. Holding the reset button for varying lengths of time, and during boot.

  4. Installing a newer firmware from ftp://pftpintl:F0rt1intl@support.fortinet.com

I've gleaned this information from random blogs. I can't find an actual manual, just spec sheets and sales pamphlets.

3

Reset Button: When enabled (default state), resets the unit to its factory default settings if pressed during the first 30 seconds after a reboot -- Fortinet KB

Resetting a lost admin password - PDF

  • This worked. Not enough points to upvote. – Nick C. Jan 15 '14 at 15:11
1

Methods above did not work for me.

Just had success with

  1. cycle power
  2. press and continue to hold reset button, through boot

    • Status blinks fast
    • flashes through eth lights
    • Status blink slow
    • Status blinks very fast.
  3. release button, unit reboots.

  4. Able to login with defaults.
0

Here are the exact steps that Nick took:

1) Install FortiExplorer. Connect the usb cable to the router and go to the web view. First just try ‘admin’ and no password. If that fails, you’ve gotta reset it.

3) Download a firmware from the Fortinet ftp server: ftp://pftpintl:F0rt1intl@support.fortinet.com

4) Upload the firmware to the router.

5) Unplug the power. Plug it back in and wait for the router to boot up.

6) Use a pen to hold the reset button for about 5 seconds within 30 seconds of the router booting up.

7) At this point I was unable to access the web view. Maybe try rebooting again and see if it works. If it does, you’re done.

8) Install the new firmware that you uploaded in step 4. Reboot and login with ‘admin’ and no password.

I took those exact steps and it worked on one of our FortiGate 60Ds. Just hitting the reset button for 5 seconds did not work.

  • 1
    Apparently, Nick used better formatting. And as the question was already answered, what does this add? – Ricky Beam Jan 26 '15 at 21:01
0

To do the manual reset you must wait for the Fortigate unit STATUS light to turn GREEN before pushing the reset button.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.