1

I am configuring a switch for the 1st time (Cisco Nexus N9000 Switch) to do some server performance testing in my lab.

I have the serial console working and can log into the switch and run commands.

I want to do the following

1) Give the switch a static IP for remote management
2) Activate all the ports on the switch
3) Create a few VLANs with 8 or more ports each

The commands that I have tried so far for 1,2&3 haven't worked. I would really appreciate how I can do 1,2 & 3

  • 1
    Have you looked at the manual? – Zac67 Apr 26 at 6:26
  • 2
    So which commands did you try, and what error message did you get? – Teun Vink Apr 26 at 6:58
  • 1
    Welcome to NE, we hope you will both contribute to and learn from this community. You could improve your question by editing it to add more details. You may find our Question Checklist helpful when editing your question. – YLearn Apr 26 at 19:58
1

First you need to make sure this switch is in Nexus OS mode. This switch is delivered from CISCO in ACI mode, to configure 1,2 & 3 you need to make it in nexus mode which requires below steps:

  1. Install the Nexus OS into switch: You can contact TAC or may refer online
  2. Check Show version: it should show the NX OS
  3. Now you can configure 1,2,3

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.