5

When I show a switch interface information, there are line protocol and Link:

Switch-A(config-if)# show interface gigabitethernet 0/3 

Gi0/3 up, line protocol is up (connected)
Bridge Port Type: Customer Bridge Port

Hardware Address is 0c:c4:7a:fd:ca:1e 
MTU  1500 bytes, Full duplex, 1 Gbps,  No-Negotiation
HOL Block Prevention enabled.
Input flow-control is off,output flow-control is off

Link Up/Down Trap is enabled 

I want to know what's them? I know one is administrator can shutdown and the other is physical connect.

5

For this particular interface, the line protocol is ethernet.

The Link Up/Down Trap is enabled message is telling you that the SNMP trap for when the link goes up or down, for whatever reason (admin up/down, cable inserted/disconnected, etc.), is enabled.

  • do you mean the admin up/down will cause the Link up/down? – 244boy May 16 at 6:02
  • when I admin down it, there will Gi0/3 down. – 244boy May 16 at 9:44
3

On Cisco equipment, the physical interface can have the following states:

enter image description here

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.