I'm trying to enable eigrp for ipv6 in packet tracer but is seems to only have ospf and rip for ipv6.

Is this a recent limitation?

  • Did any answer help you? If so, you should accept the answer so that the question doesn't keep popping up forever, looking for an answer. Alternatively, you can provide and accept your own answer.
    – Ron Maupin
    Dec 15, 2019 at 4:34

1 Answer 1


No It is support for IPV6 Eigrp, You need to enable eigrp on Interface level.

 int gigabitEthernet 0/0/0
 ipv6 address AB80::10:1/64
 ipv6 eigrp 10
  • I did, try to enable it on the interface level of a svi vlan 100, however after ipv6 there is no eigrp command in packet tracer. There only appears ospf and rip. Jul 4, 2019 at 15:18

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.