0

i have only one cisco 2960 running at location. Switch neither connected in stack nor any cable connected, still in running configuration, it shows switch is in stack and having two two interfaces card, ex. 1/0/1 and 2/0/1. What is the reason or how to remove stack configuration?

2
  • 1
    please provide configurations..
    – infra
    Commented Jul 18, 2019 at 10:16
  • Did any answer help you? If so, you should accept the answer so that the question doesn't keep popping up forever, looking for an answer. Alternatively, you can provide and accept your own answer.
    – Ron Maupin
    Commented Dec 15, 2019 at 4:59

1 Answer 1

1
#show run | in provision

Then from conf t:

(config)#no switch [stack-member-number] provision [switch-version]

By filling in the stack-member-number and switch-version from the show run results.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.