I need to achieve the same result of these two commands which are on Cisco CLI but on Meraki GUI

so we have two valid public IP address(,31) on outside interface of MX64

both of 'em want to be forwarded to two seperate Webservers

Switch6500(config)#ip nat inside source static tcp 80 tcp 80

Switch6500(config)#ip nat inside source static tcp 80 tcp 80

How can I do that? I couldn't find a place to specify what outside IP+Port combination I want to be forwarded to this Private(local) IP add+port combination, all they have is either interface(uplink) alone or IP address without port alone


  • Did any answer help you? If so, you should accept the answer so that the question doesn't keep popping up forever, looking for an answer. Alternatively, you can provide and accept your own answer.
    – Ron Maupin
    Dec 15, 2019 at 6:26

1 Answer 1


You're looking for "1:1 NAT": https://documentation.meraki.com/MX/NAT_and_Port_Forwarding/Port_Forwarding_and_NAT_Rules_on_the_MX

  • as weird as it is, this feature is not in 1:1, it's on 1:m part of this switch for doing IP:Port pair to IP:port pair Aug 15, 2019 at 17:59
  • Strange, it's in 1:1 on one of my MX64's I just checked. Welcome to Meraki!
    – boomi
    Aug 15, 2019 at 22:45

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge that you have read and understand our privacy policy and code of conduct.

Not the answer you're looking for? Browse other questions tagged or ask your own question.