0

I have 2 switches . Hp2620 and 2610. I have an ip phone connected to the switch(i use mab to authenticate) and pc(connected to the ip phone) with dot1x. Each work individually bu they dont work together. Can anyone help me with a config example to make this work. Thank you.

3
  • The default is that only one (first seen) MAC address per switch interface for MAB. You need to enable Multi-Authentication Host Mode or Multihost Mode (Cisco supports this, but I do not know about HP).
    – Ron Maupin
    Jun 1, 2020 at 19:27
  • Actually i want to make it work like the multi-domain method on cisco. When I plug them individually it works but when i connect the pc to the phone it doesnt.
    – user19215
    Jun 1, 2020 at 19:33
  • I doubt that mode works with HP since it uses CDP to negotiate that with a phone.
    – Ron Maupin
    Jun 1, 2020 at 19:42

0

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.