2

I am trying to configure a packet tracer based on a scenario. I am wondering if there is a way to get a GigabitEthernet 0/5 and a GigabitEthernet 0/6 interface on any of the switches?

I have tried them all with no luck, and there is no expansion options to meet the requirement.

Suggestions are much appreciated

Improve this question
4
  • 3
    Seems not (to my surprise I must admit), but what for? Since this is only an emulator in which you can't push traffic, there's no difference between fastethernet and gigabitethernet ports. It would be only a cosmetic difference.
    – JFL
    Jun 10, 2020 at 11:29
  • Packet Tracer is very limited because it is only intended to get you through the CCNA exam.
    – Ron Maupin ♦
    Jun 10, 2020 at 12:11
  • Hm my previous comment was wrong (see fracjackmac answer).
    – JFL
    Jun 16, 2020 at 13:39
  • Did any answer help you? If so, you should accept the answer so that the question doesn't keep popping up forever, looking for an answer. Alternatively, you can post and accept your own answer.
    – Ron Maupin ♦
    Dec 17, 2020 at 17:45

1 Answer 1

Reset to default
4

I have a copy of PacketTracer, Version 7.2.0.0226, that contains a 3650-24PS Multi-Layer Switch with twenty-eight (28) Gig ports...

  • 1/0/1 - 1/0/24 (fixed copper)

  • 1/1/1 - 1/1/4 (copper or fiber SFPs)

Improve this answer

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.