1

I made a small separated networks on packet tracer and used OSPF protocol to route between networks. Although The connect is Successful when I write 'show ip ospf neighbor' Command in CLI router X which is connected with Three networks, I get This Results:

Neighbor ID     Pri   State           Dead Time   Address         Interface
192.168.11.2      0   FULL/  -        00:00:33    192.168.10.2    Serial0/0/0
192.168.12.1      0   FULL/  -        00:00:39    192.168.12.1    Serial0/0/1

Those Are the interfaces that The router is connected to another router, but It doesn't show The address OF the Third interface, Where The router is connected to a switch. Image of what I mean: enter image description here

is that natural or what?

0

1 Answer 1

3

You have three routers. They each have two neighbors. What you see are not the interfaces on router X, they are the neighbors of router X.

If you want to see the OSPF interfaces on router X, type show ip ospf interface brief.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.