4

So I recently purchased some media converters to take our T1 lines, that currently run over copper stretch far past it's limits, over some new fiber we had installed. They didn't work. I am a novice with T1 connections so I'm not sure what the issue is.

After some research it looks like there are special media converters that I need to use for the T1 lines. Is this accurate? Is there no way for me to get these media converters to work? Maybe a switch with VLAN ports? Any ideas are welcome.

Improve this question

1 Answer 1

Reset to default
8

Unless the media converter you've bought are specifically marketed as T1 Fiber Extender/Converter, it won't work.

T1 isn't Ethernet even if it's using RJ-45.

Regular media converter are for Copper Ethernet to Fiber Ethernet, not T1 signals

A quick google search with "t1 fiber copper converter" will yield various manufacturers that are making the bona fide converter you need.

Improve this answer
2
  • Thanks. My researched turned up the same thing but I was hoping for a way out.
    – Securus
    Jun 9, 2014 at 13:55
  • @Securus the obvious question would be what are these T1s being used for? if it's just point to point IP data then it should be easy enough to reconfigure the routers to put that traffic on an ethernet port. If it's something else then things may be harder.
    – Peter Green
    Dec 18, 2015 at 10:25

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.