I'm trying to mirror all traffic using the configuration below, but it doesn't seem to be working. Please help.
set interfaces ge-1/3/4 encapsulation ethernet-bridge
set interfaces ge-1/3/4 unit 0 family bridge
set bridge-domains PORT-MIRROR1 interface ge-1/3/4.0
set forwarding-options port-mirroring instance PM-INSTANCE-1 input rate 1
set forwarding-options port-mirroring instance PM-INSTANCE-1 family any output interface ge-1/3/4.0
set firewall family any filter MIRROR-ANY-INS1 term 1 then accept
set firewall family any filter MIRROR-ANY-INS1 term 1 then port-mirror-instance PM-INSTANCE-1
set chassis fpc 1 pic 3 port-mirror-instance PM-INSTANCE-1
set interfaces ae2 unit 0 filter input MIRROR-ANY-INS1
set interfaces ae2 unit 0 filter output MIRROR-ANY-INS1
The ingress and egress traffic is mirrored:
# run show interfaces ae2 extensive | match bps | refresh 1
---(refreshed at 2023-09-18 10:48:35 ICT)---
Link-level type: Ethernet, MTU: 9192, Speed: 1Gbps, BPDU Error: None, MAC-REWRITE Error: None, Loopback: Disabled, Source filtering: Disabled,
Minimum links needed: 1, Minimum bandwidth needed: 1bps
Input bytes : 2642988529 3728 bps
Output bytes : 603764001 3456 bps
Input bytes : 0 0 bps
Statistics Packets pps Bytes bps
---(refreshed at 2023-09-18 10:48:36 ICT)---
Port Mirror output traffic as below:
# run show interfaces ge-1/3/4 extensive | match bps | refresh 1
---(refreshed at 2023-09-18 10:48:28 ICT)---
Link-level type: Ethernet-CCC, MTU: 1514, MRU: 1522, LAN-PHY mode, Speed: 1000mbps, BPDU Error: None, Loop Detect PDU Error: None,
Input bytes : 438029 0 bps
Output bytes : 0 0 bps
Flow control: Symmetric, Remote fault: Link OK, Local link Speed: 1000 Mbps, Link mode: Full-duplex
% bps % usec
Input bytes : 0 0 bps
Output bytes : 0 0 bps
Is something wrong because my port mirror output traffic is nothing?
