1

The following documentation has been read regarding EIGRP in order to configure it on Switch1 and 2.

The Switches are connected via a port channel. However, neither Switch1 is able to find Neighbor2 located on Switch2 nor Switch2 is able to find Neighbor1 located on Switch1.

Configuration:

Switch1:

router eigrp 1
 network 50.0.0.0
 eigrp router-id 50.50.50.50
 eigrp stub connected static
!

Switch2:

router eigrp 2
 network 50.0.0.0
 eigrp router-id 50.50.50.51
 eigrp stub connected static
!

EIGRP neighbors:

Switch 1:

Switch1#sh ip eigrp neighbors detail
EIGRP-IPv4 Neighbors for AS(1)

Switch 2:

Switch2#sh ip eigrp neighbors detail
EIGRP-IPv4 Neighbors for AS(2)

1 Answer 1

6

Your AS numbers need to match. Change either switch2 to router eigrp 1 or change switch1 to router eigrp 2 and reimplement the routing configuration on the device that is changed.

1
  • After following the steps from the answer, executing sh ip eigrp neighbors detail results in: H Address Interface Hold Uptime SRTT RTO Q Seq \n 0 50.50.50.51 .... Now it works. Thank you for the answer.
    – 030
    Jul 14, 2014 at 13:55

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.