Questions tagged [backups]

For questions about backups in relation to on topic network devices. For instance, you want to backup your network device, before rebooting it.

Filter by
Sorted by
Tagged with
0
votes
0answers
22 views

Nortel L4 Switch 3408, Backup configuration to files

I need a solution for backup the "cfg & info dump" to files. To do this, there is a few information to be convinced that [/cfg/ptcfg command] include the [/info/dump]. So, do I just need to /cfg/...
0
votes
2answers
550 views

F5 backup whole bigIP configuration and save UCS

I'm trying to export my current F5 bigIP configuration into a file and later create a replica of the same bigIP with that configuration. This reference mentioned following this: Create the UCS ...
1
vote
1answer
626 views

ftp user in cisco nexus 5010 switch

How to create a ftp user in cisco nexus 5010 switch to archive for autobackup. Below command is working for normal switches like cisco c3850 but not for Nexus switches. Please advise #FTP Local User ...
2
votes
2answers
151 views

Schedule command on Avaya Ethernet Routing Switch 4524GT

I'm trying to do some network monitoring and discovered an older network device which escaped everyone's attention. Through the CLI, I can copy my config to a tftp server but I was wondering if it was ...
1
vote
1answer
238 views

10Gbe Network Setup, Freenas Backup and File Sharing

I have a small office network that has: ISP: 100Mbps up / 100Mbps down Firebox M200 (Firewall/Router) 8 x 1Gbe ports / 3.2Gbps Firewall throughput Cisco SG200 1Gbe Switch / 26 port *Planned 10Gbe ...
2
votes
1answer
3k views

What are .pkg files in flash drive?

I have a Cisco 3650 switch and want to backup my IOS via tftp. System image file is flash:packages.conf #sh flash cat3k_caa-base.SPA.03.03.05SE.pkg cat3k_caa-drivers.SPA.03.03.05SE.pkg ...
2
votes
3answers
119 views

Branch Site Network Redundancy w/ ISDN PRIs

One of my branch sites far out of town experiences primary link failure from time to time which is very disruptive. All they have in terms of connectivity is a T1 for data and PRI for voice. Would it ...
2
votes
1answer
128 views

RANCID saving config lines out of order [closed]

On one of the configs backed up by RANCID, it has switched two lines. Lines 241 and 242, for example, have been swapped. It does this every time the backup is grabbed, and it only happens on this ...
7
votes
1answer
3k views

Cisco ISE backup shows as success but no data was written to backup server

I'm trying to back up a Cisco ISE server (version 1.2.0.899 patch 4) via sftp. I configuered a repo via the web gui. I added the hostkey (for the backup server) via the command line. I make sure the ...
1
vote
2answers
299 views

Are data back up solutions shown on the network diagram?

I have started my first job and apart from designing a network (which I have done) I'm to decide about back up solutions. I use Visio for diagramming but I have no idea whether a data back up should ...
16
votes
7answers
99k views

What are the differences between VRRP and HSRP?

Are there any significant differences between VRRP and HSRP?
10
votes
3answers
1k views

Routing with seperate WAN link for backups

We have two geographically separate data centers. We are preparing to implement a new WAN connection (dark cloud) that would be used only for backup traffic. The servers will have two NIC cards (...