Questions tagged [failover]

For questions about failover in a network aspect. For instance, if you have a stack of switches and you have problems with master/slave failover or a Firewall setup with multiple hot standby's where it doesn't failover correctly. Failover can also be used in relation to a network design.

7 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
3
votes
0answers
1k views

Dual ISP NAT Failover Not Working

I have a Cisco 1841 router with an HWIC-4ESW switchport module attached to it. Fa0/0 is connected to ISP1 and Fa0/1 to ISP2 and both are "ip nat outside", the switchports are in interface Vlan 1, ...
1
vote
0answers
22 views

Using PBR or similar for an IP SLA for a C1111-8P-TLELA with a dynamic Cellular WAN IP

I am trying to get 4G Failover working on a Cisco C1111-8P-LTELA router. I have a known working solution that I usually use with IP SLA, and a local PBR route-map that forces traffic out of the ...
1
vote
2answers
67 views

Data Center Warm Disaster Recovery

We are planning to create a backup data center for warm disaster recovery. Critical services will be replicated on application level to the new data center, all other services will be backuped daily. ...
1
vote
0answers
224 views

Cisco ASA 5585-x Failover Virtual MAC address

I have configured Cisco ASA 5585-x with Active/Standby mode, cisco best practice saying you should use Virtual MAC address on interface to avoid traffic disruption when you do failover. now question ...
1
vote
0answers
138 views

How to keep the VRRP failover mechanism?

referring to the diagram below, we have 2 VLAN's for voice, primary route for VLAN1 (red) is the left side, and VLAN2 (green) is the right. As it stands we have a nice easy setup, where VRRP kicks ...
1
vote
0answers
362 views

ASA cluster with named interface running PPPoE

I am trying to configure an A/S firewall cluster, and I have the interface configured as a PPPoE client. When I try to configure the clustering on ASDM, I get a message saying that high availability ...
0
votes
0answers
43 views

pfSense: Bundling carp VIPs

When configuring Carp for pfSense as recommended by their guide, this issue appears: when pulling out the WAN cable (simulating, say, a cable failure, switch port failure, or network card failure), ...