Questions tagged [huawei]

A tag for questions involving Huawei networking hardware or software.

9 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
2
votes
0answers
24 views

Huawei S9706 FIB/RIB Size

I searched a lot on internet but could not find how much is route table size for the following Huawei configuration : EH1D2SRUDC00 Main Control Unit 2x EH1D2X16SFC0 16-Port 10GBASE-X Interface Card (...
1
vote
0answers
24 views

Huawei USG OSPF P2MP Network Limits

Good day! Configured an L2TP over IPSec tunnel on Huawei USG6500E. On the tunnel interface prescribed ospf type p2mp. I connect clients to this tunnel. When 32 clients are connected, the OSPF ...
1
vote
0answers
70 views

traffic of AF41 marking under interface

I have used port-queue commands most of the time to check traffic status under BE, EF, AF4. But I haven't found command to check for AF41 to AF42 on Huawei VRP or cisco IOS. How can check traffic of ...
1
vote
0answers
1k views

Huawei: Configuring netstream

I'm trying to configure NETSTREAM, but I'm a little confused. Following this tutorials: Configuring NetStream export and Huawei: NetStream Configuration. I'm configuring netstream on Huawei Ne20e ...
1
vote
0answers
484 views

Traffic Statistics per VLAN

I'm using Huawei s6720 and I would like to monitor traffic per vlan, example: # Interface GigabitEthernet0/0/6 port link-type trunk port trunk allow-pass vlan 200 300 400 500 # I can verify ...
1
vote
0answers
72 views

Policy routing with IS-IS

three routers are connected where Router A connected to router B A (gig0/0/0 ip address 10.10.1.1)====> B(gig0/0/0 ip address 10.10.1.2 A(gig0/0/0=> ip address 10.11.1.1===>B(gig0/0/...
0
votes
0answers
21 views

Ansible cli_config module instead ce_config

I have a Huawei siwtch S5720 that does not works with the ce_config module. I'm trying to use the cli_config module but I'm getting the error below: "module_stderr": "Traceback (most ...
0
votes
0answers
49 views

The Huawei switch does not accept the new operating system image

I got four HUAWEI CE6881-48S6CQ. I updated three of them to new software. But the fourth switch print the next error: <HUAWEI>startup system-software flash:/CE6881-V200R019C10SPC800.cc all Info: ...
0
votes
0answers
12k views

Huawei Router Telnet and SSH configuration - Authentication

I am following Huawei user guide to enable telnet server and telnet service to a port. However, whenever I am trying to do a telnet, I see this error and the connection times out - HUAWEI %%01SOCKET/...