What's the deal with Deno? We talk with a major contributor to find out. Listen now.

Questions tagged [interface]

For questions about a physical or virtual interface on a network device. For instance: Interface configurations, troubleshooting and security.

Filter by
Sorted by
Tagged with
10
votes
4answers
154k views

What can cause “FastEthernet is up, line protocol is down” on a Cisco Switch?

I wonder what can cause the first line output of the command show interfaces to be: FastEthernet is up, line protocol is down. In other words, Is the cable that is connected to the local interface, ...
10
votes
2answers
4k views

Network Gateways vs Interfaces

When looking at the contents of a routing table section on the Wikipedia article on Routing Tables, it contains a table as an example of a routing table with two headings which have an unclear ...
7
votes
4answers
4k views

Why do I get “% Warning: use /31 mask on non point-to-point interface cautiously” when I use a /31 subnet mask?

Why do I get % Warning: use /31 mask on non point-to-point interface cautiously when I use a /31 subnet mask over Ethernet, and why am I not able to ping from R1 to R2 when both the interfaces have ...
6
votes
2answers
1k views

How does a router know the MTU of a network?

I've done several exercises where you're given the MTU of a net or subnet, but I wonder how routers know the MTU of the nets they're connected. I've learnt that in OSPF protocol this information is ...
6
votes
1answer
1k views

Cisco ASA startup-config command ordering for sub-interfaces

In relation to another question on this forum, Moving interface names on a Cisco ASA while maintaining the rest of the configuration in place, I modified the startup-config on my Cisco ASA 5525-X from....
3
votes
2answers
667 views

Cisco: Two interfaces on one network

I'm a newbie to Cisco Equipment and IOS, but got myself a Cisco 2811 and have been playing with it and getting to grips with the basics quite happily. One problem i'm having is trying to get two ...
1
vote
1answer
199 views

What's the relationship of a Router with its loopback interface in logic?

I have a Router1 with a loopback 0 connected to the Router2: the interface brief is bellow: Router1>show ip interface brief Interface IP-Address OK? Method Status ...