Questions tagged [load-balancing]

For questions about load balancing network devices. For instance, you are setting up a port-channel with load-balancing or you want to load balance between two firewalls.

Filter by
Sorted by
Tagged with
1
vote
1answer
1k views

SonicWALL Load Balance Term

Currently I am learning about load balance method available on SonicWALL. I have some question regarding the load balance methods for 1) round robin 2) spill over 3) percentage. Assuming there are two ...
2
votes
2answers
604 views

How can a TCP Flow with smaller congestion window have higher throughput?

It might be a stupid question, but as far as I understood the CNWD dictates the rate of a TCP flow. I created a "load-balancer" that split single packets on two paths of 10Mb/s. This introduces some ...
2
votes
2answers
345 views

BGP loadsharing not working

I am trying to build resilient core networking by using BGP. I have two routers, R1 and R2, which are connected to the single ISP. ISP has two routers (let's call them R3 and R4). My have successfully ...
0
votes
1answer
354 views

MikroTik: bisschoff load balancing problem? [closed]

I'm using bisschoff load-balancing .its really good and works fine.but it has a problem. The problem is when a adsl line don't have access to internet , it don't disable automatically and vice versa. ...
4
votes
2answers
286 views

BGP loadbalancing: full bgp table vs default route only

I'm trying to achieve this: http://www.cisco.com/c/en/us/support/docs/ip/border-gateway-protocol-bgp/13762-40.html#conf3. The only difference here is that I am being sent the full BGP routing table. ...
1
vote
1answer
337 views

Load Balance with TL-R470T+

I have the TL-R470T+ and i have two different internet connections from two different ISPs. One 39 Mbps and the other 5 mbps and i want to get 44 mbps. When i installed the router on the speedtest ...
4
votes
3answers
25k views

Load balancing with multiple ISP, two routers and firewall

I have two ISP connections on two Cisco 2901 routers, in front of Cisco ASA-5515 firewall. I need to configure failover load balancing network. Two Cisco 2901 router with dual (different ISP) ...
8
votes
1answer
814 views

Junos VRF equal-cost, multi-next-hop static routes not balancing

I am load balancing traffic on dual, same size links aggregating to the same VRF on the PE router (Juniper MX5 JunOS 11.4). Traffic from the CE (Cisco) is balancing nicely but I need get the reverse ...
3
votes
2answers
953 views

How to set a zero cost link in OSPF

Can one set a link's cost to zero in OSPF? This could be desirable to force load-balancing in certain cases. For example, suppose there are four routers A, B, C, and D, and two hosts X and Y, with ...

1
2