Questions tagged [network]

For questions about Networking that includes design, and use of a network, the physical cabling, hub, bridge, switch, router, and so forth. Anything in relation to networking and its technologies.

28 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
5
votes
0answers
152 views

Cisco nexus 9396 rebooted with reason xbar_client

Today my one of cisco nexus 9396PX switch got rebooted and this is what i found, based on following logs what could be wrong? We don't have Cisco support for this switch, trying to see if i can get ...
4
votes
0answers
262 views

Cisco nexus STP loopguard

I have cisco nexus switches in vPC and they are connected to HP c7000 blade center switches and all my c7000 blade server has Linux Bridge is running, i believe something went wrong somewhere in Linux ...
3
votes
2answers
126 views

What is the advantage of Supervised Machine Learning over Deep Packet Inspection in Network Traffic Classification?

As per the definition of Deep Packet Inspection (DPI), it uses signatures for packet filtering. Supervised Machine Learning can help put a label on a packet which does not get identified by Deep ...
1
vote
0answers
309 views

How to check vlan interface traffic on Cisco nexus 9k

I have Cisco N9K-C9396PX L3 switch which has VLAN interface configured for my LAN gateway and i want to monitor how much traffic vlanXXX handling, I have configured SNMP monitoring to pull interface ...
1
vote
0answers
96 views

sflow configuration Cisco Nexus 9396PQ

We have Cisco a Nexus switch with M12PQ 12x40G GEM expansion card. Today when i enabled sflow on one of 40G interface i got following error: # sflow data-source interface e2/12 In order to enable ...
1
vote
0answers
204 views

Help with network setup issue (small network)

I am trying to set up a new network for a small business, and I can’t figure out what I have misconfigured. Hoping someone can provide me with some ideas. I have 6 VLANs set up. 10.10.10.0/24, 10....
1
vote
0answers
223 views

Simple Token Bucket - Policing - Terms - CIR, CBS

I have gone through token bucket algorithm. However, I am struggling to apply this knowledge into the real devices like CISCO, etc. So, for QoS policing, interface meter. I am trying to understand ...
1
vote
0answers
51 views

QOS - the need for it and verifying it

Just some straightforward questions, hope gurus here can shed some light 1) show int - output queue -> this is the hardware queue (tx-ring) or this is the software queue ? if I see drop, this means ...
1
vote
0answers
474 views

Even ips pinging but odd ips not pinging

We have following network, and i have multiple host connected to TOR switches configured with public IPs. We have HSRP running on vPC switches. interface Vlan100 description *** Public VLAN *** ...
1
vote
0answers
246 views

How does a Switch Fabric Module work internally?

I am interested how does a switch fabric module work internally. What interfaces does it use to physically connect the I/O modules on switches? Where are the CAM / MAC tables of the switch? Are ...
0
votes
1answer
19 views

BGP influence outbound traffic based on prefix

I have two router core1 and core2 connected with ISP router border1 and border2 using eBGP peer and i have 5 public subnect (/24). My ISP sending me default route instead of full BGP table. Question:...
0
votes
0answers
23 views

vPC + HSRP load-balancing issue on Cisco CML 2.0 lab

I am playing with new cisco cml 2.0 lab simulator and seeing strange behavior not sure if its real issue or limitation of cisco lab. dist1 and dist2 is my vPC (NSOX 9000v) peers, and tor1 is IOSv ...
0
votes
1answer
34 views

How is the PPP protocol byte-oriented as well as bit-oriented?

Many articles considered PPP as a byte-oriented, and the others mention it as a bit-oriented. +----------+----------+----------+----------+------------ | Flag | Address | Control | ...
0
votes
0answers
14 views

using SNAP/ LLC on ethernet

Why is it not desirable to use Logical Link Control (LLC) and Sub-Network Access Protocol (SNAP) on Ethernet 802.3 frames while carrying IP packets when it is often used for wireless networks?
0
votes
2answers
38 views

Multi LAN network does the main router to the internet need to be in its own subnet?

I have to design a network where there are 4 within which are different number of VLANs with varying number of hosts per VLAN depending on the building. My confusion lays in the main router, does it ...
0
votes
1answer
49 views

What steps must be accomplished in each layer of the TCP/IP model to connect a website?

What steps must be accomplished in each layer of the TCP/IP model to connect a website?
0
votes
0answers
25 views

Cisco Router Interface Connection Problems

I am new to networking and am configuring, I am trying to setup my connections in packet tracers for 3 different routers to talk to each other over Serial ports as attached. However, I did notice ...
0
votes
0answers
14 views

Comparing ETX with PRR with retransmissions

Expected number of transmissions (ETX) and packet reception ratio (PRR) are two routing metrics that exist. Based on my understanding, the packet reception ratio reflects the link quality. If you ...
0
votes
0answers
37 views

Understanding TCP congestion control

Why is the congestion avoidance here [6,14] and [18,25]. Why not [6-10] and [18-22]? Other examples I have seen online suggest otherwise: For example here: https://www.researchgate.net/figure/TCP-...
0
votes
0answers
11 views

Header Size of Sigfox packet

I am trying to find the header size range for a Sigfox packet and I can't seem to find it anywhere. I have looked on the Sigfox website and it says that the maximum payload is 12 bytes but it says ...
0
votes
0answers
14 views

what is role-based source authentication network misconfiguration mean?

what is role-based source authentication misconfiguration mean? in a Context of SDN where i have assigned priority to a candidate flow rule , recognized 3 standard authorization levels among flow ...
0
votes
1answer
36 views

Can Northbound interfaces (REST API) in a Software Defined Network (SDN) be used to manipulate QoS parameters?

I am working on a project involving Quality of Service (QoS) manipulation in Software Defined Networks (SDNs). I know that the following parameters affect the QoS in an SDN: Time information (inter-...
0
votes
0answers
50 views

Compatible peap+freeradius+openldap

On my new job I have inherited a service wpa2-enterprice with peap+freeradius+openldap. As NAS we use ArubaIAP with enabled function "eap-termination". And this bundle works well! Little deep: In ...
0
votes
1answer
42 views

Design of 2 Lans Connected to a Watchguard m570 firewall

I have this architecture (without the firewall). I bought a Watchguard M570 as Firewall to add it in my network. My Question is : Could i use my watchguard and connect this one to my 2 LoadBlancers ...
0
votes
0answers
19 views

Is it possible to simulate ad-hoc network in ONE Simulator?

Is it possible to simulate ad-hoc network in ONE Simulator? I am trying to simulate ad-hoc network. Is it possible?
0
votes
0answers
52 views

Cisco ASA Security Warning: Untrusted server cert after asa crash and reload

We have Cisco ASA 5505 working VPN anyconnect and it's been almost 1 year no issue, but last week it got crashed and reboot itself and after that we found it started throwing warning like following: ...
0
votes
0answers
18 views

Bmon - Find average bandwidth usage of a tool

I am using bmon network analyser and I am wondering if the way to calculate the average bandwidth usage of a scanning tool like Nmap, is to measure the total number of RX and TX bytes and divide them ...
0
votes
0answers
77 views

I'm unable to see packet drops after configuration of QoS policy

I aim to send iperf traffic from Endpoint1(Client) to Endpoint2 (Server) with the following SR path = {R1, R2, R3, R4, R3, R2, R1, R2, and R3}. First of all, the traffic generated by iperf from ...