Questions tagged [pppoe]

For questions about PPPoE (Point-to-Point Protocol over Ethernet), which provides a method to connect two PPP nodes by encapsulating PPP frames inside Ethernet frames.

6 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
5
votes
1answer
249 views

Juniper ERX 310 traffic not going more than 710 mbps?

We have a Juniper ERX 310 configured as B-ras, as per specifications of the router, we should be able to terminate 8000 PPP sessions, but we notice that traffic on the router interface not going more ...
4
votes
2answers
1k views

SonicWall TZ210 PPPoE on WAN interface, need transparent bridging to DMZ

I've got a SonicWall TZ210 which connects to the WAN via PPPoE on the X1 interface. I've got a /29 subnet routed into the box, and everything is running fine. Now, I need to route one of the WAN IP ...
3
votes
0answers
446 views

Policy Based Routing (not matching packets) - Virtual Template

I have this configuration runnning : Larger image I tested the policy based routing int the lab using two linksys router acting as ppp clients of the Cisco 7206VXR and another linksys emulating the ...
2
votes
0answers
139 views

Not able to ping Dialer1 interface

I have setup a PPPoE server and client. I can't ping any IP address connected on the ISP router. I'm stil figuering out why that doesn't work. But the most simple problem currently is: I can't ping ...
2
votes
0answers
149 views

Router as PPPOE concentrator, PPPOE clients unable to get to DMZed static NAT server

I've been trying to figure out this problem, and I'm just not up to the task. I have a Cisco 2911 router as follows: Internet connection on GigabitEthernet0/1. Which has it's own static IP: A.B.C.38/...
0
votes
1answer
190 views

Configure 2 PPPoE wan trunk port

I have 2 routers from the same ISP but different public IP that works with PPPoE and I need to connect both into the same firewall (Watchguard). Both PPPoE have the same user, password and VLAN, so I ...