All Questions
Tagged with snmp cisco-commands
5 questions
2
votes
1
answer
79
views
Cisco snmp-server single user for multiple snmp versions
Attempting to maintain SNMP v2c compatibility while implementing SNMP v3 on cisco switch 5506cx.
Would a user that was previously used for v2c see issues with v2c if it is added to a v3 group?
For ...
- 25
2
votes
1
answer
1k
views
How to copy Running Config from a switch using SNMP commands on Cisco ASR1002?
I trying to copy a running config from a cisco switch using the snmp commands on a Cisco ASR1002.
On the Cisco ASR I enabled snmp-server manager by using this command:
conf t
snmp-server ...
- 41
6
votes
2
answers
4k
views
SNMPv3 Setup - Cisco 3750
I am not a network guru by any means but need to setup our router/switch to use SNMPv3. I am installing What's Up Gold on our system and configured the settings (changed for this post) as follows:
...
- 163
5
votes
1
answer
675
views
Enable traps on FIB (Forwarding Table) changes
I've been working for weeks to enable sending traps for FIB changes on our Cisco 2600 router. I finally found this command is responsible for that:
snmp-server enable traps cef peer-fib-state-change
...
- 235
6
votes
2
answers
4k
views
SNMP and Syslog in configuration
Really stupid questions guys so I apologize. When sending Syslog messages to a server we use the command logging x.x.x.x. I get that part.
SNMP is used to gather stats or change configurations on ...
- 151