Questions tagged [tunnel]

For questions about network tunnels.

10 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
4
votes
0answers
456 views

Dual-Hub DMVPN Outage

Our backup links have always utilized a GRE tunnel based VPN to a hub. Recently we installed a second hub and migrated the primary links to GRE tunnel based VPN with EIGRP to handle routing between ...
3
votes
0answers
200 views

IPSec Tunnel not coming up: Issue with ACL?

I'm trying to bring up a IPsec tunnel between router and a bridge. I can see the Ipsec tunnel configurations are up and running but I think I have made a mistake in the ACL and hence the encr and decr ...
1
vote
0answers
692 views

Why do the tunnel protocol on these two router show different values

Two routers R1 and R2 have a tunnel built between them in the 103.103.103.0/24 network. The end point of the tunnel are 75.75.75.2(on R1) and 76.76.76.2(on R2). Can anyone explain why does the Tunnel ...
1
vote
0answers
387 views

OSPF over IPIP tunnel doesn't work for CSR 1000v in AWS

I literally have the following topology shown in the figure below. I have 4 VPCs, each VPC has 3 subnets (1 for the VM instance and the other 2 for interfaces). Each VPC hosts a Cisco CSR 1000v in ...
1
vote
0answers
76 views

Using IPv6 6in4 tunnel with multiple VLANs, or LAN Interfaces?

I have a pfSense router, and I've setup a Hurricane 6in4 IPv6 tunnel by following this guide: http://thirdinternet.com/wp-content/uploads/2017/11/Configure-6in4-Tunnel-in-pfSense.pdf It all seems to ...
1
vote
0answers
332 views

GTP support in OpenFlow

I know there is a "tunnel id" metadata matching field which was introduced in the 1.3 openflow release, if I'm not mistaken. However, are there any actions in supporting the encapsulation and ...
1
vote
0answers
4k views

Connection terminated for peer x.x.x.x. Reason: IPSec SA Idle Timeout

I have configured an IPsec Site - site VPN tunnel with Cisco ASA on both sides.there is no issue with the phase 1 of tunnel.but frequently connection towards some IPs become timedout only from some ...
0
votes
0answers
38 views

How to configure ZPF with Tunnel?

I am trying to configure ZPF in a Cisco 4331 router in Packet Tracer. I have a tunnel interface for GRE tunnel in this router. But I am not being able to assign this tunnel interface to any zone due ...
0
votes
0answers
510 views

Q-IN-Q Tunnel between cisco and mikrotik not work

i have try to make A Q-IN-Q tennel between two router (cisco and Microik) through cisco switch in mikrotik VLAN ID = 10 IN interface ether1 VLAN ID = 20 in interaface Vlan10 ip address in interface ...
0
votes
0answers
55 views

IPSec Tunnel is up but no Communication with End Systems?

I need help for IPSec tunnel. Currently, I am working on a small task to create remote access between my laptop and office router, in order to access the office LAN network. IPSec tunnel is working ...