Hot answers tagged

4

ACL use either hosts or networks, not ranges. Networks are bounded by power of 2 values. Your range doesn't correspond to a single network. The best you can do is split your range into 4 valid networks: 192.168.1.10/31 for IP 10 & 11 192.168.1.12/30 for IP 12 to 15 192.168.1.16/30 for IP 16 to 19 192.168.1.20/32 for IP 20 So you don't have to use 10 ...


3

The authoritative name server should be in the domain's NS record. In Windows, this can be looked up nslookup -type=ns somedomain.com In Linux, something like dig somedomain.com NS +noall +answer should work.


3

If you want to limit your output to just the names of the routing-tables, then something like: show route 192.169.0.0/24 | match dest will do the trick


3

I don't know how to show it in the CLI, it's not in the output of show interfaces verbose or show port-statistics afaik... Another option could be to query it using SNMP. Avaya supports the IF-MIB, and the ifTable entries contain an ifLastChange value (.1.3.6.1.2.1.2.2.1.9): The value of sysUpTime at the time the interface entered its current ...


2

I'm not sure what i can do. If there are any other ways i can run that script and receive the I/O without manually typing in the command, with or without using ssh or rsa key pairs, im all ears. Do not attempt to drive interactive pty sessions with bash shell... it's like trying to turn a screw with the pointy-end of a hammer claw.... no worky. Use ...


1

While you can manually configure a sticky address, it is not usually used that way (and in fact Cisco recommends against it): You can configure MAC addresses to be sticky. These can be dynamically learned or manually configured, stored in the address table, and added to the running configuration. If these addresses are saved in the configuration ...


1

When configuring a VLAN's it's recommended by Cisco to use underscores instead of spaces. Hence the correct configuration would be: Switch(config-vlan)#name VLAN_10 and Switch(config-vlan)#name VLAN_20


1

Use an underscore instead. ;) Spaces aren't usually allowed in the names of interfaces. Sometimes you can name with a space if you use Quotes "VLAN 10" but YMMV.


Only top voted, non community-wiki answers of a minimum length are eligible