3

First and foremost is to verify bandwidth utilisation on ISP. Internet link . And futher look for any packet drop in your entire end to end infrastructure or any congestion in network and even verify CPU ,RAM and disk resource utilisation in network devices like firewall, routers and switches connected in your topology .


3

When you do a packet capture on an SRX you specify the filename you want to save the PCAPs as and then the SRX will append the name of the interface it caught them on. [edit forwarding-options packet-capture] user@host# set file filename testpacketcapture See here - https://kb.juniper.net/InfoCenter/index?page=content&id=KB11709 The captured file is ...


3

Solved! I checked the /var/log/httpd.log log and I found the required interface (not the one I thought to): httpd: 0: GET IFNAME WORKED st0.6 httpd: 0: GET ALLOWED FAILED st0.6 now I can reach the Web Gui. Thanks to all.


2

There isn't a show command that shows this information. Invalidated sessions are sessions that are due for cleanup/deletion, holding them in memory so that they could be viewed may present other issues. The behavior can change slightly depending on some configuration settings (i.e. set security flow tcp-session rst-invalidate-session). If your issue is a ...


1

Connecting directly into the switch, use the wired network to see if the problem is still there. If not, it's the wireless network - interference, thick walls, long range, overload, ... If the problem persists directly on the switch, check the switch's interface counters for errors. FCS, giants, runts indicate cabling problems on that port. If any port ...


1

You probably need one or two more PEMs. This Juniper document is a good planning resource for SRX3600 power budgeting. All the PEMs in the SRX3600 load-share so the problem isn't which slots are occupied by PEMs but rather the total available power supply. There are no zones or similar complications like there are in some other Juniper chassis.


1

Don't use obsolete or ill-suited devices. Just buy a switch.


1

Will the inactivity timeout set for the application "TCP-ALL" of 900 trump the default value of 1800 for junos-ssh if the application-set were matched in a security policy? Assuming you had both applications are configured in the same security policy, yes order matters (see below). Does it matter if the order of the applications in this application set ...


Only top voted, non community-wiki answers of a minimum length are eligible